Customer service: +32 (0)3 227 08 20

The Proportions, Symmetry and Polish of Diamonds

The angles and finish of any diamond are what determine its ability to handle light, which leads to brilliance.

The Proportions of Diamonds

As shown in the images below, when a diamond is well- cut, light enters through the table and travels to the pavilion where it reflects from one side to the other before reflecting back out of the diamond through the table and to the observer’s eye.

This light is the brilliance we mentioned, and it’s this flashing effect that makes diamonds so mesmerizing. In a poorly cut diamond, the light that enters through the table reaches the facets and then ’leaks’ out from the sides or bottom of the diamond rather than reflecting back to the eye. Less light reflected back to the eye means less brilliance.

Bonnes proportions du diamant Diamant trop profond
Shallow cut diamond Well cut diamond Deep cut diamond
Light escapes trough the paviilion
before it can be reflected.
Light is reflected from one facet
to another and then dispersed
through the top of the stone .
Light escapes trough
the opposite side of the
pavilion.

 

The GIA standards for Ideal - Excellent cut are describe below.

 

Diamond Symmetry

Symmetry measures how well the facets match the other facets. A diamond cut with very good or excellent symmetry means that if you were to look at all the facets and compare to one another, they would look very uniform with very little variance.. This dosn't mean however the diamond is not cut too deep or too shallow.

Diamond Polish

Polish is a measure of the surface finish. If a diamond is only " Fair" or " Average” it does not allow maximum transmission of light though the facets, due to it's " rough" surface texture. “Very Good” or “Excellent” Polish by most lab standards is usually the top cut grade which is mostly preferred. Polish graded above “ Good” is not detectible to the naked eye.